Tolerance
A tolerance is the amount a finished garment may differ from its specification and still be accepted.
Why it exists. Fabric stretches, and people cut and sew it. No factory hits every number exactly. A tolerance turns "close enough" into a figure agreed before production, so a dispute is settled with a tape measure.
Measurement tolerances. These sit on the measurement chart as a plus or minus beside each point of measure. Half an inch on body length and a quarter inch on a neck opening are typical. Small measurements get small tolerances.
Other tolerances.
- Fabric weight. See GSM.
- Placement. A logo or number is measured from a fixed point, with an allowance either way.
- Quantity. A purchase order can let the factory ship slightly over or under. That works for stock. It does not work for a roster, where every player needs a jersey.
Fiber content on labels. In the United States, the Federal Trade Commission allows a 3 percent tolerance on fiber content claims. A label that says 40 percent cotton can cover 37 to 43 percent. The allowance is for unintended variation in manufacturing, and there is none when the label names a single fiber.
At inspection. A measurement outside tolerance is a defect. Decide in advance whether it counts as major or minor, and write that beside the AQL.
On a team order. Two jerseys of the same size can differ by the full tolerance and both be correct. Tell the coach before the players compare them.
Updated .
Sources
- Threading Your Way Through the Labeling Requirements Under the Textile and Wool Acts, Federal Trade Commission
Articles that use this term
- Tech pack checklist: the ten parts a factory needsA checklist of the ten parts of an apparel tech pack, what each must contain, the gaps factories complain about most and how to test yours before sending it.
- Team uniform sizing: how to measure players and get sizes rightHow to collect sizes for a team order: body and garment measurements, reading a size chart, youth and adult overlap, fit by sport and sizing kits.
- US labeling and safety rules for custom apparel: a plain summaryWhat US rules require on clothing labels, and what changes for children's apparel: fiber content, country of origin, RN, care labels and flammability.
- AQL inspection for apparel: sample sizes, limits and a final checklistHow AQL sampling works for garment orders: lot size, inspection level, sample size, accept and reject numbers, defect classes and a final inspection checklist.
- How to vet a custom apparel manufacturerFive steps to vet an apparel factory before you send it real orders: fit, the questions to ask, a paid sample, references and audits, and a small first order.
- Jersey fabric guide: mesh, interlock, birdseye, dazzle and what GSM meansThe fabrics team jerseys are made from, how they differ, what fabric weight in GSM tells you, and which fabric suits which sport and decoration method.
